This leads me to believe it is an issue with the NVR but I can't figure out what or why. sections of home page is not loading properly) in Google Chrome browser. An NVR reboot does not fix the issue, but turning off a couple of the cameras does. From setting it up to handling basic commands, this guide has the basics you. When I Stream the cameras from the NVR On "Fluent" or "Balanced" usually works ok however once on "3840*2160" or "5MP" (for the lower quality cams) the issues start. This is unacceptable performance as it should be 24/7 continuous, uninterrupted recording as advertised. Make sure the subject is within the illumination range. Change the Installation Environment (Applies to all above functions) Avoid IR reflection. The issue is also when trying to play back clips in high format. Refer to: Set Up the Record Encode for Reolink Cameras. This also affects the recordings as I have went back and tried to view recordings and some skip time. Streams stop, time stops ticking, feed goes green. Even after disconnecting the Reolink Client device, the streams appear degraded by watching the NVR directly (HDMI) for an extended duration of time. Even after disconnecting the Reolink Client device, the streams appear degraded by watching the NVR directly (HDMI) for an extended duration of time. The bitrate shown in the Reolink Client will change from about 8192 down into the 2000s and sometimes to 0 during a complete freeze of the stream. The bitrate shown in the Reolink Client will change from about 8192 down into the 2000s and sometimes to 0 during a complete freeze of the stream. My cameras do not show up on the firmware page. Reolink Setup 8.0.5.exe ReolinkClient 8.1.24.exe Reolink Setup 8.2. Being a little OCD, I am not thrilled with the changing 'name' of the Reolink Client. It actually worked this morning, and I can access the recordings on the Reolink website. (also have moved the slider on Automatic Client Update, hoping that will prevent it from updating itself.) If no one gets back to you, I can put 8.2.6 on DropBox. The second icon from the top left here called 'Output'. And I was able to use the old Reolink Windows Client to change the NVR Video Output back to 1080p. The problem was the video resolution output from the NVR had changed. After much puzzling why, I managed to fix it. Bought the cameras a week ago, and the cloud has worked on the app until this afternoon. I had a problem with the screen physically connected to my NVR. However the issues start when streaming any camera feed from the NVR. Recorded videos won’t load in the cloud tab in the app. (2) E1 ZOOM IPC_515SD6 V3.0.0.716_21112408Īdding each individual camera to to Reolink APP the streams are fine even in max. ġ - RLN16-410 16 Port 4K NVR Connected to Unifi POE switchĭevice models with firmware listed below:Īll latest versions of (Reolink Client Windows 10, Android, iOS) and Camera and NVR firmware as of today 1/1/22 Having same issues as described in this thread.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |